NOK 0,00
(frakt: 0,00)
littleBits light sensor, Lyssensor, littleBits, Flerfarget, 95,2 mm, 190,5 mm, 12,7 mm
Varenr.: [4978051] | Producent: Littlebits | Model-nr.: 650-0111 | EAN: 0859477003706
Ikke på lager
Varen er ikke på lager.
Frakt 69,00 - Instabox - Velg din nærmeste pakkeboks.
Fraktprisen er basert på levering til dette postnummer: - Skift postnummer
Oppgi postnummer for levering.
Se alle alternativer
| Instabox - Velg din nærmeste pakkeboks | 69,00 |
| Bring - Hentes på Posten | 75,00 |
| PorterBuddy - Fleksibel hjemlevering - levert på døren på kvelden | 159,00 |
| Bring - Fleksibel hjemlevering - Levering til døren (om kvelden i større byer) | 224,00 |
Utsolgt
Varen er ikke på lager.
NOK
241,00
eksklusiv MVA 192,80
Totalt inkl. frakt
310,00
Gi meg beskjed når varen er på lager igjen.
Denne funksjonen krever at man er logget inn. Opprett en bruker og liste systemet for å holde styr på fremtidige kjøp eller ønskelister.
Opprett bruker
Login
Opprett bruker
Login
Send på mail
The light sensor Bit can turn your circuit on and off by detecting the brightness or darkness of the environment they are in. control your circuit's with light! The amount of light shining on the sensor will change how your circuit behaves. It's a great way to activate your circuit, and is perfect for alarms!
The light sensor is similar to a dimmer. It measures how much light is shining on it and activates the Bits that follow it based on the amount of light. It has two modes: "light" and "dark". As of the environment gets brighter, the Bits that follow the sensor will gradually turn on. The light sensor also has a "dark mode" that allows it to work in reverse. As it gradually gets darker the Bits that follow will gradually turn on.
Use the small slider on the board to adjust how much light it takes to change the signal. Sliding right increases sensitivity, left decreases it. Older versions of this Bit have a small screw dial instead of the slider. Use the included purple screwdriver to turn this dial.
The light sensor is similar to a dimmer. It measures how much light is shining on it and activates the Bits that follow it based on the amount of light. It has two modes: "light" and "dark". As of the environment gets brighter, the Bits that follow the sensor will gradually turn on. The light sensor also has a "dark mode" that allows it to work in reverse. As it gradually gets darker the Bits that follow will gradually turn on.
Use the small slider on the board to adjust how much light it takes to change the signal. Sliding right increases sensitivity, left decreases it. Older versions of this Bit have a small screw dial instead of the slider. Use the included purple screwdriver to turn this dial.