NOK 0,00
(frakt: 0,00)
MakerBot - Ekte blå - 907 g - PLA-filament (3D) - for Replicator Fifth Generation, Z18
Varenr.: [1706833] | Producent: Makerbot | Model-nr.: MP05776 | EAN: 0817913011043
Ikke på lager
Varen er ikke på lager.
Frakt 69,00 - Instabox - Velg din nærmeste pakkeboks.
Fraktprisen er basert på levering til dette postnummer: - Skift postnummer
Oppgi postnummer for levering.
Se alle alternativer
| Instabox - Velg din nærmeste pakkeboks | 69,00 |
| Bring - Hentes på Posten | 75,00 |
| PorterBuddy - Fleksibel hjemlevering - levert på døren på kvelden | 159,00 |
| Bring - Fleksibel hjemlevering - Levering til døren (om kvelden i større byer) | 224,00 |
Utsolgt
Varen er ikke på lager.
NOK
802,00
eksklusiv MVA 641,60
Totalt inkl. frakt
871,00
Gi meg beskjed når varen er på lager igjen.
Denne funksjonen krever at man er logget inn. Opprett en bruker og liste systemet for å holde styr på fremtidige kjøp eller ønskelister.
Opprett bruker
Login
Opprett bruker
Login
Send på mail
Every filament color is comprehensively quality tested at both 100-micron and 200-micron layer resolutions on the MakerBot Replicator 2 to verify that the filament will perform every feature that MakerBot MakerWare and MakerBot Desktop software offer.
If you’re new to 3D printing, MakerBot PLA Filament is a good material to start with because it’s easy to use and performs well on most prints.
MakerBot PLA Filament adheres well to acrylic and to MakerBot Build Plate Tape. Prints with a large bottom layer may have a tendency to curl. To prevent curling, use rafts.
Store MakerBot PLA Filament in a cool, dry place as it can absorb moisture from the air and long-term exposure to humidity can compromise filament quality and performances.
Be sure your build plate is level, clean and oil-free before printing.
If you’re new to 3D printing, MakerBot PLA Filament is a good material to start with because it’s easy to use and performs well on most prints.
MakerBot PLA Filament adheres well to acrylic and to MakerBot Build Plate Tape. Prints with a large bottom layer may have a tendency to curl. To prevent curling, use rafts.
Store MakerBot PLA Filament in a cool, dry place as it can absorb moisture from the air and long-term exposure to humidity can compromise filament quality and performances.
Be sure your build plate is level, clean and oil-free before printing.