NOK 0,00
(frakt: 0,00)
SCHWALBE SV12 26 x 1,2 - 1,9 (30-47x559-597) Presta (avtakbar ventilkjerne) 40 mm
Varenr.: [10601691] | Producent: Schwalbe | Model-nr.: 10423343 | EAN: 4026495099103
Fjernlager
Varen er på fjernlager, leveringstiden er 4-5 hverdager. Mere info
Leveringsalternativer - Velges i kassen
Instabox - Velg din nærmeste pakkeboks
59,00
Bring – Leveres til pakkeboks nær deg
59,00
Bring – Leveres på hentested nær deg
59,00
PorterBuddy - Fleksibel hjemlevering - levert på døren på kvelden
174,00
Bring - Fleksibel hjemlevering - Levering til døren (om kvelden i større byer)
199,00
Vis alle leveringsalternativer (5)
Fraktprisen er basert på levering til dette postnummer: - Skift postnummer
Oppgi postnummer for levering.
NOK
88,00
eksklusiv MVA 70,40
Totalt inkl. frakt
147,00
Denne funksjonen krever at man er logget inn. Opprett en bruker og liste systemet for å holde styr på fremtidige kjøp eller ønskelister.
Opprett bruker
Login
Opprett bruker
Login
Send på mail
A bicycle tube is predominantly made of Butyl rubber. Butyl is a very elastic and airtight synthetic rubber. But as with the tire, other fillers are necessary to make up the rubber compound. The quality of a tube can vary significantly depending on the rubber compound. For instance Schwalbe tubes have extremely high air retention and elasticity. This high elasticity allows a wide range of different tire sizes to be covered.
There is a difference between heat molded and autoclave tubes. Vulcanizing in a mold improves the uniformity of wall thickness, thus reducing weight and improving air retention. For this reason the autoclave tubes which can be produced easier have become less common over the past years. Schwalbe tubes have always been made using the heat molding process.
Every tube also needs a valve, which is bonded to the tube during the vulcanizing process.
There is a difference between heat molded and autoclave tubes. Vulcanizing in a mold improves the uniformity of wall thickness, thus reducing weight and improving air retention. For this reason the autoclave tubes which can be produced easier have become less common over the past years. Schwalbe tubes have always been made using the heat molding process.
Every tube also needs a valve, which is bonded to the tube during the vulcanizing process.